Toyota Land Cruiser 200 2015 Manual page 504

3-7. Other interior features
■
Programming a rolling code system
If your device is rolling code equipped, follow the steps under the
heading "Programming HomeLink
steps listed below.
STEP 1
Locate the learn button on the ceiling mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
motor for the location of the learn button.
STEP 2
Press the learn button.
Following this step, you have 30 seconds in which to initiate
below.
STEP 3
Press and hold the vehicle's programmed HomeLink
for 2 seconds and release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
STEP 4
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
504
LC200_OM_OM60L83U_(U)

" before proceeding with the

signal and operate the garage door.
STEP

button

buttons.
3