Advertisement
Read Before Operating
1. Be sure to operate with safe ground wire!!!
2. Check the voltage before using it. The correct voltage is 110-120v.
3. Turn off the machine when not in use.
4. Grasp the handle firmly when opening.
5. Keep children away from the machine.
6. Do not attempt to press products that are not intended for normal heat transfer
use.
Operation Procedures
1. Plug in and turn on the power switch. The red light will illuminate.
2. Adjust the temperature by pressing the set button. Use arrows to choose desired
temperature. Press the set button again.
3. Allow 20-30 minutes for machine to heat to set temperature.
4. Adjust the timer by pressing the set button. Use arrows to choose desired time
duration. Press the set button again..
5. Pressure adjustment: Set pressure to a firm, comfortable lockdown. The
pressure may have to be adjusted depending on the transfer application
instructions. Turn to the right to tighten the pressure, turn left to lower the
pressure.
Connecting Your Heat Press To An Electrical Outlet
•
Connect the power cord into a properly grounded electrical outlet with a
sufficient amperage rating.
•
Your Pro World Heat Press requires a full 8 amp grounded circuit for 120 volt
operation.
•
Extension cord use on the heat transfer machines is not recommended.
•
Extension cords ,if used, should be as short as possible and not less then 12
gauge. Heavy duty extension cords are highly recommended in this case.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN CAUSE:
1. Erratic controller functions.
2. Inaccurate displays and slow heat-up.
3. The fuse to pop/break.
4. Internal malfunctions prevent the machine to perform properly
Video Tutorial
A video tutorial is also available at http://www.proworldinc.com/videos
OPERATION INSTRUCTIONS
www.proworldinc.com
Page 3
Advertisement
