Before Starting The Equipment - EINHELL 44.662.30 Operating Instructions Manual

Anleitung RT_BS_75_SPK1__ 25.09.13 09:13 Seite 12
GB
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle
Vibration emission value a ≤ 2,5 m/s
h
K uncertainty = 1,5 m/s 2
Additional handle
Vibration emission value a ≤ 2,5 m/s
h
K uncertainty = 1,5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
12
88 dB(A) used.
3. Health damage caused by hand-arm vibrations if
3 dB
the equipment is used over a prolonged period or
99 dB(A)
is not properly guided and maintained.
3 dB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
2
adjustments to the equipment.
5.1 Dust extraction
2
5.1.1 Installing the dust extractor adapter
(Figure 3/Item 15)
Slide the dust extractor adapter (15) on to the
connection for the dust extractor (6).
You can then connect a suitable dust extractor (a) to
the dust extractor adapter (15) (dust extractor not
supplied).
This will provide excellent dust extraction on the
workpiece.
Check that all the parts are properly connected.
Important. The vacuum cleaner you use for the
extraction work must be suitable for the workpiece
material.
5.1.2 Installing the dust collection box
(Figure 4/Item 14)
Push the dust collection box (14) to the dust extractor
connection (6). Remove the dust collection box in
reverse order.
The dust is extracted directly via the grinding/sanding
belt into the dust container.
Important.
For health safety reasons it is imperative that you use
a dust container or a dust extraction system via the
dust extraction adaptor!
5.2 Adjusting the additional handle
(Fig. 5/Item 2)
Slacken the screw (1) and move the additional handle
(2) to its optimal position. Lock the additional handle
(2) in place by tightening the screw (1).