Stanley FatMax KFMCD628D2K Original Instructions Manual
  1. Manuals
  2. Brands
  3. Stanley Manuals
  4. Drill
  5. FatMax KFMCD628D2K
  6. Original instructions manual

Stanley FatMax KFMCD628D2K Original Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
5
3
4
2
1
9
8
7
6
www.stanley.gb
KFMCD628

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FatMax KFMCD628D2K and is the answer not in the manual?

Questions and answers

Related Manuals for Stanley FatMax KFMCD628D2K

Summary of Contents for Stanley FatMax KFMCD628D2K

  • Page 1 KFMCD628...
  • Page 2 English (original instructions)

  • Page 4: Intended Use

    If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) Your Stanley Fat Max KFMCD628 Impact drill has been protected supply. Use of an RCD reduces the risk of designed for screwdriving applications and for drilling in wood, electric shock.
  • Page 5 (Original instructions) ENGLISH c. Disconnect the plug from the power source and/or the f. Do not expose a battery pack or tool to fire or excessive battery pack from the power tool before making any temperature. Exposure to fire or temperature adjustments, changing accessories, or storing power above 130 °C may cause explosion.

  • Page 6: Residual Risks

    (example:- working with wood, especially Chargers oak, beech and MDF.) Use your Stanley Fat Max charger only to charge the bat- tery in the tool with which it was supplied. Other batteries Vibration could burst, causing personal injury and damage.
  • Page 7 Problems are indicated by one LED flashing in different patterns. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Stanley Fat Max Service Bad Battery Centre in order to avoid a hazard.

  • Page 8: Important Charging Notes

    Set the collar to the lowest torque setting. 75°F (18°- 24°C). d. If charging problems persist, take Tighten the first screw. the tool, battery pack and charger to your local Stanley If the clutch ratchets before the desired result is Fat Max service center.

  • Page 9: Troubleshooting

    This will help reduce jamming. Maintenance Make sure switch turns drill on and off. Your Stanley Fat Max tool has been designed to operate Drilling in wood over a long period of time with a minimum of maintenance. Holes in wood can be made with the same twist drill bits used Continuous satisfactory operation depends upon proper tool for metal or with spade bits.

  • Page 10: Protecting The Environment

    Electrical and Electronic Equipment Regulations 2012, S.I. Voltage 2012/3032 (as amended). 0-430/0-1700 For more information, please contact Stanley Fat Max at the No-load speed following address or refer to the back of the manual. Max. torque The undersigned is responsible for compilation of the...

  • Page 11: Ec Declaration Of Conformity

    For more information, please contact Stanley Fat Max at the following address or refer to the back of the manual. The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Stanley Fat Max. Patrick Diepenbach General Manager, Benelux...
  • Page 12 United Kingdom Stanley Fat Max Tel. 01753 511234 270 Bath Road Fax 01753 572112 Slough, Berkshire SL1 4DX www.stanleytools.co.uk NA076298 REV-0 09/2021...

This manual is also suitable for:

Fatmax kfmcd628

Table of Contents