Battery Removal And Installation - VTech Marble Rush Shuttle Blast-Off Set Instruction Manual

WARNING
Do not discharge any object other than the projectile provided with
this toy.
ATTENTION
Ne viser ni les yeux ni le visage.
ATTENTION
Ne pas utiliser d'autres projectiles que ceux fournis avec ce jouet.
INSTRUCTIONS

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA (LR6/AM-3) batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4