Battery Removal And Installation - VTech Spinning Activity Snail Instruction Manual

INSTRUCTIONS

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling
up on one end of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the battery
box. (For best performance, alkaline
batteries or fully charged Ni-MH
rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
4
4
4
4