Getting Started; Battery Removal And Installation - VTech Switch & Go Pterodactyl Dragster Instruction Manual

GETTING STARTED

Exit Try-Me Mode:
To exit try-me mode, need to wake up the unit first, then transform
from Dino mode to Vehicle Mode. Normal play mode will then proceed.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Locate the battery cover on
the bottom of the unit. Use a
screwdriver to loosen the screw
and then open the battery cover.
3. If a used batteries is present,
remove this batteries from the unit
by pulling up on one end of the
battery.
4. Install 2 new AA (AM-3/LR6)
batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
4