Supplementary Information - Mitsubishi Electric EHSC-MEC Service Manual

12

SUPPLEMENTARY INFORMATION

12-1. Refrigerant collecting (pumpdown) for split model systems only
Refer to "Refrigerant collection" in the outdoor unit installation manual or service manual.
12-2. Back-up operation of boiler
Heating operation is backed up by boiler.
For more details, refer to the installation manual of PAC-TH011HT-E.
<Installation & System set up>
1. Set DIP-SW 1-1 to ON "With boiler" and SW2-6 to ON "With Mixing tank".
2. Install the thermistors THWB1 (Flow temp.) and THWB2 (Return temp.) *1 on the boiler circuit.
3. Connect the output wire (OUT10: Boiler operation) to the signal input (room thermostat input) on the boiler. *2
4. Install one of the following room temp. thermostats. *3
Wireless remote controller (option)
Room temp. thermostat (local supply)
Main remote controller (remote position)
*1 The boiler temperature thermistor is an optional part.
*2 OUT10 has no voltage across it.
*3 Boiler heating is controlled on/off by the room temp. thermostat.
<Remote controller settings>
1. Go to Service menu > Heat source setting and choose "Boiler" or "Hybrid". *4
2. Go to Service menu > Operation settings > Boiler settings to make detailed settings for "Hybrid" above .
*4 The "Hybrid" automatically switches heat sources between Heat pump (and Electric heater) and boiler.
12-3. Multiple outdoor units control
To realize bigger systems by using multiple outdoor units, up to 6 units of the same model can be connected.
The hydrobox can be used as a slave unit for multiple outdoor unit control.
For more details, refer to the installation manual of PAC-IF061/062B-E.
PAC-IF051/052B-E cannot be connected to the hydrobox.
Check the model name of connecting master unit.
<DIP switch setting>
• Set DIP SW4-1 to ON "Active: multiple outdoor unit control".
• Keep DIP SW4-2 OFF (default setting) (master/slave setting: slave).
• Set DIP SW1-3 to ON when the hydrobox is connected to a DHW tank.
OCH571D
93