Table of Contents
Advertisement
The Initial Settings Menu
Using the Initial Settings
menu
The Initial Settings menu gives you complete
control in setting up your DVD player,
including audio, and video output settings,
audience limitation settings, among others.
If an option is grayed out it means that it
cannot be changed at the current time. This
is usually because a disc is playing. Stop the
disc, then change the setting.
1
Press SETUP and select 'Initial Set-
tings' from the on-screen display.
Audio Settings
Play Mode
Initial Settings
2
Select the setup category from the list
on the left, then select an item from the
menu list to the right.
3
Make the setting you want.
• The language options shown in the on-
screen display illustrations on the
following pages may not correspond to
those available in your country or
region.
Disc Navigator
Setup Navigator
Digital Audio Out settings
Digital Out
• Default setting: On
You only need to make this setting if you
connected this system to an AV receiver (or
other component) using one of the digital
outputs.
Initial Settings
Digital Audio Out
Digital Out
Video Output
Dolby Digital Out
Language
DTS Out
Display
96 kHz PCM Out
Options
MPEG Out
If at any time you need to switch off the
digital audio output, set this to Off, other-
wise leave it On.
Note that you can't switch on/off the optical
and coaxial outputs individually.
Dolby Digital Out
• Default setting: Dolby Digital
You only need to make this setting if you
connected this system to an AV receiver (or
other component) using one of the digital
outputs.
Initial Settings
Digital Audio Out
Digital Out
Video Output
Dolby Digital Out
Language
DTS Out
Display
96 kHz PCM Out
Options
MPEG Out
If your AV receiver (or other connected
component) is Dolby Digital compatible, set
to Dolby Digital, otherwise set to Dolby
Digital > PCM.
On
Off
Dolby Digital
Dolby Digital > PCM
07
41
En
Advertisement
Table of Contents
