Assembling The Light Kit - Hunter 51736 Installation Manual

1886
bag
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
bag
Screw two housing assembly screws from the
hardware bag halfway into the upper switch
housing. It does not matter which two screw holes
you choose.
Install a bulb into each of the sockets. When
necessary, replace with bulbs of the same
type and wattage.
7
Ceiling Bracket
Assembling the Switch Housing
2 of 6
Light Kit Screw
Feed the wire plug through the center hole of the
hood, then wrap keyhole slots around the screws
and twist counterclockwise.

Assembling the Light Kit

2 of 6
Light Kit Screw
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.Wrap light
kit keyhole slots around the screws and twist
counterclockwise.
Hanging Fan Wiring
Insert the third screw, found in the
bag, into place and then tighten all three screws.
Install the third switch housing screw. Tighten all
three screws securely.
Tab
Notch
Lift the globe and align the notches in the
globe with the tabs in the light kit. Attach
the glass bowl to the light kit by twisting it
clockwise until it snaps into place.
Canopy Blades
bag
hardware
WARNING
FAN FALL HAZARD
Make sure the hood is securely attached to the mounting
plate. Failure to properly secure all 3 assembly screws could
result in the switch housing fixture falling.
bag
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the
light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Bulbs
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
Remote