Section
04
Installation
! If installation angle exceeds 30º from hori-
zontal, the display unit might not give its
optimum performance.
! The cords must not cover up the area
shown in the figure below. This is neces-
sary to allow the amps and navigation me-
chanism to dissipate heat.
! The semiconductor laser will be damaged
if it overheats, so don't install the display
unit anywhere hot — for instance, near a
heater outlet.
! When installing the hide-away unit in the
trunk, use the extension cable (e.g. CD-
SC300E)(sold separately).
! Do not install the display unit in a position
where the opening of the LCD panel is ob-
structed by any obstacles, such as the shift
lever. This may cause interference with the
shift lever, or a malfunction of the mechan-
ism of the display unit.
24
En
The display unit
Do not cover this area.
The hide-away unit
Do not cover this area.
! Make sure you leave enough gap between
the dashboard and the LCD panel of the
display unit so the LCD panel can be
opened and closed without contacting with
the dashboard.
Dashboard
Leave gap
LCD panel
Parts supplied
Parts marked (*) are pre-installed.
The hide-away unit
Holder*
Washer faced screw
(4 mm × 8 mm)
(4 pcs.)
Frame*
The display unit
Side bracket
(2 pcs.)
Self-tapping screw
(6 mm × 16 mm)
(4 pcs.)
Side bracket (small)*
(2 pcs.)