Before Installing; Installing This Navigation System; Installation Notes - Pioneer AVIC-N5 Installation Manual

Pioneer avic-n5: install guide
Hide thumbs Also See for AVIC-N5:
Table of Contents

Advertisement

Available languages

Available languages

Installation
! GPS antenna and its lead
In addition you should lay or route each anten-
na lead as far as possible from other antenna
leads. Do not bind them together, lay or route
them together, or cross them. Such electro-
magnetic noise will increase the potential for
errors in the location display.

Before installing

! Consult with your nearest dealer if installa-
tion requires the drilling of holes or other
modifications of the vehicle.
! Before making a final installation of this
product, temporarily connect the wiring to
confirm that the connections are correct
and the system works properly.
Installing this navigation
system

Installation notes

! Do not install the display unit or the hide-
away unit in places where it may become
subject to high temperatures or humidity,
such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard or the rear
shelf.
— Places that may be splashed by rain, for
example close to the door.
! When installing the unit choose a position
that is strong enough to bear the weight of
the unit. Choose positions where the dis-
play unit or the hide-away unit can be firmly
installed, and install it securely. Unless the
display unit or the hide-away unit are se-
curely attached, the current location of the
vehicle cannot be displayed correctly.
! Do not install the hide-away unit on the
board covering the spare tire or other
places which are subject to vibration.
! When the hide-away unit is installed under
a front seat, ensure that it does not ob-
struct the sliding action of the seat.
! When installing the hide-away unit, choose
a position that ensures there will be no con-
tact with luggage. The impact of a heavy
weight or sudden shock on the hide-away
unit will adversely affect the accurate dis-
play of the current location of the vehicle.
! Avoid installing the hide-away unit in
places where it will interfere with loading
and unloading of the spare tire, jack, tools,
etc.
! Check that a disc can be ejected with the
display unit installed.
! Install the hide-away unit horizontally on a
surface within +30 degrees to –30 degrees
tolerance (within five degrees to the left or
right of your vehicle's direction of travel).
Mis-installing the unit with the surface
tilted more than these tolerances would in-
crease the potential for errors in the loca-
tion display, and might otherwise cause
reduced display performance.
Section
04
23
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents