Din Front/Rear-Mount; Din Front-Mount - Pioneer AVIC-D2 Installation Manual

Installation

DIN Front/Rear-mount

This product can be properly installed
either from "Front" (conventional DIN
Front-mount) or "Rear" (DIN Rear-
mount installation, using threaded
screw holes at the sides of this product
chassis). For details, refer to the fol-
lowing illustrated installation methods.
Before installing this product
• Remove the holder.
To remove the frame, extend top and
bottom of the frame outwards in order
to unlock it.
Loosen the screws (2.6 × 3 mm) to
remove the holder.
Screw (2.6 × 3 mm)
21

DIN Front-mount

Installation with the holder and side
bracket
1. Install the holder into the dash-
Holder
2. Install this product and fasten
3. Attach the frame if applicable.
board.
After inserting the holder into the
dashboard, select and bend the tabs
appropriate to the thickness of the
dashboard material.
(Install this product as firmly as possi-
ble using the top and bottom tabs. To
secure this product, bend the tabs 90
degrees.)
Dashboard
1 8 2
1 1 1
Holder
the screws.
Dashboard
Screw (2.6 × 3 mm)
When attaching the frame, attach it
with the grooved side pointing down-
wards.
Attach the frame with
this part facing down-
wards.