Advertisement
www.PumpAgents.com - Click here for Pricing/Ordering for Pumps and Parts
DIAGRAM 1
VENT TO
ATMOSPHERE
37068-0000
ELECTRICAL
CONNECTIONS
REASSEMBLY INSTRUCTIONS
Press seal into body with lip facing impeller; be careful
not to cock seal in bore. Install pump body on motor and
position on register; lubricate impeller bore with pump
grease. Install impeller, gasket and wearplate. Make
sure gasket surfaces are clean and smooth. Tighten
wearplate screws. Slide shaft sealing sleeve onto shaft
and seat in its bore in wearplate. Relocate centrifugal
DIMENSIONAL DRAWING
Inches (Millimeters)
U.S.A.
UNITED KINGDOM
Jabsco
Jabsco
Cape Ann Industrial Park
Bingley Road, Hoddesdon
Gloucester, MA 01930
Hertfordsire EN11 OBU
Tel: 978.281.0440
Tel: +44 (0) 1992 450145
Fax: 978.283.2619
Fax: +44 (0) 1992 467132
© Copyright 2003, ITT Industries
Jabsco Pumps 37010-0097
MOUNTING
BRACKET
VIEW A
TO VENTED
LOOP
MOTOR COVER
CANADA
Fluid Products Canada
55 Royal Road
Guelph, Ontario N1H 1T1
Tel: (519) 821.1900
Fax: (519) 821.2569
Printed in U.S.A.
TO
NEGATIVE
TO
POSITIVE
PUSH BUTTON
SWITCH
TO
NEGATIVE
DISCHARGE TO
HOLDING TANK
impeller about 1/8" from wearplate and secure with set
screw. Position macerator housing around centrifugal
impeller then put chopper plate on end of shaft and
secure with lock nut. Install O-ring in O-ring groove in
wearplate surface (a little grease will help hold in place).
Aligning key on top of macerator housing with slot in
base, slide macerator assembly into base. Secure pump
assembly with the four screws.
THE PRODUCTS DESCRIBED HEREIN ARE SUBJECT TO
THE JABSCO ONE YEAR LIMITED WARRANTY, WHICH
IS AVAILABLE FOR YOUR INSPECTION UPON REQUEST.
JAPAN
NHK Jabsco Company Ltd.
3-21-10, Shin-Yokohama
Kohoku-Ku, Yokohama, 222
Tel: 045.475.8906
Fax: 045.475.8908
All Rights Reserved
VIEW A
VENTED
LOOP
WATER
LINE
INLET
GERMANY
Jabsco GmbH
Oststrasse 28
22840 Norderstedt
Tel: +49-40-53 43 73 -0
Fax: +49-40-53 53 73 -11
Form: 43000-0613
Rev. 08/2003
Advertisement
