Recoil-Starter Handle
Pull the recoil-starter handle
engine.
Figure 21
1. Recoil-starter handle
Kickstand
The kickstand
(Figure
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
To use the kickstand to install the transport wheels,
lower the kickstand to the ground and step down
on the loop while pulling up and back on the
lower-center handle
CAUTION
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand loop and use only the
lower-center handle to raise the machine.
Attempting to raise the machine onto the
kickstand any other way can cause injury.
(Figure
21) to start the
23) is mounted to the rear of
(Figure
22).
g018268
1. Lower-center handle
1. Kickstand
•
To prevent the machine from tipping backward
when removing the reel, lower the kickstand and
push in the locking pin to lock it in the S
position
(Figure
15
Figure 22
2. Kickstand loop
Figure 23
2. Kickstand loop
24).
g018793
g239955
ERVICE