Table of Contents
Advertisement
Service Brake
The service brake
(Figure
front side of the handle. Pulling back the lever applies
the service brake.
You must disengage the brake before you engage the
traction drive. If you operate the machine with the
brake engaged, the machine moves, but with a high
resistance and increased power consumption.
Figure 18
1. Parking-brake latch
Parking-Brake Latch
Use the parking-brake latch
service brake. Rotate the parking-brake latch toward
the brake handle to hold the service brake in place.
Pull the brake lever to release.
Note:
You cannot move the traction-control lever
while the latch is engaged.
On/Off Switch
The On/Off switch
(Figure
the control panel. Move the switch to the O
to start the engine and the O
the engine.
Operator-Presence Control (OPC)
You must engage the operator-presence control
(Figure
15) before you engage the traction lever. If you
release the OPC during operation, the traction lever
returns to neutral and the engine continues to run.
18) is located on the left
2. Service brake
(Figure
18) with the
15) is located on the top of
position
N
position to shut off
FF
Choke Lever
The choke lever
of the engine. The lever has 2 positions: R
C
. Move the lever to the C
HOKE
starting a cold engine. After the engine starts, move
the lever to the R
1. Choke lever
g016853
Fuel-Shutoff Valve
The fuel-shutoff valve
located on the left front of the engine near the choke
lever. The valve has 2 positions: C
Move the lever up to the C
store or transport the machine. Open the valve before
you start the engine by rotating the lever down.
1. Fuel-shutoff valve—C
14
(Figure
19) is located on the left front
position when
HOKE
position.
UN
Figure 19
2. Fuel-shutoff valve
(Figure 19
and
Figure
LOSED
position when you
LOSED
Figure 20
position
LOSED
and
UN
g024364
20) is
and O
.
PEN
g196011
Advertisement
Table of Contents
