Removing The Front Panel; Attaching The Front Panel; Resetting The Microprocessor; About The Demo Mode - Pioneer Super Tuner IIID DEH-P7100BT Operation Manual

Cd receiver
Hide thumbs Also See for Super Tuner IIID DEH-P7100BT:
Table of Contents

Advertisement

Available languages

Available languages

Before You Start

Removing the front panel

1
Press
to open the front panel.
2
Grip the left side of the front panel and
pull it gently outward.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3
Put the front panel into the provided
protective case for safe keeping.

Attaching the front panel

% Reattach the front panel by holding it
upright to the unit and clipping it securely
into the mounting hooks.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1
Remove the front panel.
Refer to Removing the front panel on this page.
2
Press RESET with a pen tip or other
pointed instrument.
RESET button

About the demo mode

This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing button
BAND/ESC/CANCEL when power to this unit
is turned off while the ignition switch is set to
ACC or ON cancels the reverse mode. Press
button BAND/ESC/CANCEL again to start the
reverse mode.
Feature demo mode
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Press
DISP/SCRL during feature demo operation to
cancel the feature demo mode. Press
DISP/SCRL again to start. Remember that if
the feature demo continues operating when
the car engine is turned off, it may drain bat-
tery power.
Section
01
9
En

Advertisement

Table of Contents
loading

Table of Contents