Powerboost Function; Limitation On Use; To Activate; To Turn Off - Siemens EH9 SK1 Series Instruction Manual

Powerboost function

The Powerboost function can be used to heat large amounts of
water more quickly than the power level

Limitation on use

This function is available on all hotplates, provided that no other
hotplate in the same group is operating, (see picture). If this is
not the case, the and
› Š
hotplate display; then it will automatically set the power level
In group 2, the powerboost function may be activated at the
same time for all hotplates (see picture).
*URXS 



Time programming function

This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■

Turning off a hotplate automatically

Enter the cooking time for the required hotplate. The hotplate
turns off automatically once the time has elapsed.
How to program
Select the required power level.
1.
Press the symbol of the desired hotplate. The hotplate
0
2.
display shows and the indicator
‹‹
Select the required cooking time in the programming panel.
3.
The possible previous setting is, from left to right 1, 2, 3, etc.,
up to 10 minutes. Within the next 10 seconds, continue
passing through the options in the programming panel until
reaching the desired time.

The cooking time will be displayed for 10 seconds then begin
to count down.
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by
one minute, if it is held down the time is automatically
increased to 99 minutes.
.
Š
symbols will flash on the selected
*URXS 

 


*URXS 
comes on.
x


To activate

Select the power level
1.
Press the programming panel located above the
2.
The function has been activated.

To turn off

. Press the programming panel located above the
Š
The Powerboost function has been deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
Once the time has elapsed
The hotplate switches off. The beep sounds and the display
comes on for 10 seconds. The
‹‹
Pressing the 0 symbol turns off the indicators and stops the
beeping.
Changing or cancelling the time
Press the symbol of the desired hotplate. Change the
0
cooking time in the programming panel, or set to
Note: Any cooking time can be programmed up to 99 minutes.

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a hotplate may be cancelled or
changed:
Press the 0 symbol of the desired hotplate. Change the
cooking time in the programming panel, or set to

Timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. The hob must be
switched on. The timer can be set for any hotplate not turned
on. This function does not automatically switch off a hotplate.
How to program
Press the symbol
1.
turned on. ‹‹ lights up in the time program function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
.
Š
indicator lights up.
x
0 for the hotplate, the indicator
symbol.
@›
symbol.
@›
‹‹ .
.
‹‹
W is
9