Table of Contents
Advertisement
Important notes
•
If you operate the device with the swivel arm or a similar accessory, it
must not be turned through 180°.
•
Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
•
We recommend that you place your device on a durable, non-slip surface. In view
of the many different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
•
To ensure sufficient ventilation, the air supply and air outlet openings of
the monitor must never be blocked.
•
The mains power connection cable of the device must be provided with
a protective earth conductor.
•
Avoid using high volumes for a long period of time, to prevent causing damage to your hearing.
•
Warning about excessive sound pressure from headphones:
Excessive sound pressure from headphones can cause loss of hearing.
Setting the equalizer to the maximum value increases the headphones output
voltage and thus increases the sound pressure.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable set.
•
The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.
•
The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on the outer sheath.
•
For devices which are mounted on a desk or table, type SVT or SJT cable sets may be
used. For devices which sit on the floor, only SJT type cable sets may be used.
•
The cable set must be selected according to the rated current for your device.
•
If necessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,
Transportation
Retransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
8
Fujitsu
Advertisement
Table of Contents
