Table of Contents
Advertisement
8.14 Fine feed handwheel
When the controls are set for the Fine feed using
handwheel position (see Table 2), the Fine Feed
Handwheel (B, Figure 8-6) can be used for manual fine
feed control in either upward or downward direction of
quill. Set feed direction control (C, Figure 8-7) at neutral
position.
Remove
handwheel
Failure to comply may cause injury.
8.15 Automatic feed operation
Feed trip adjustment sets the point at which quill will reset
during automatic feed.
Refer to Figure 8-9.
Remove
handwheel before power feed
operation. Failure to comply may cause injury.
1.
Move micrometer adjusting nut to allow for ample
spindle travel.
2.
Use Coarse Feed Handle (D) to advance quill to
point where the feed should stop. Lock quill (E).
3.
Engage Feed Trip Cam Lever (A) by pulling away
from head assembly.
4.
Move Micrometer Adjusting Nut (F) against Quill
Stop (G).
5.
Continue turning Micrometer Adjusting Nut (F) until
Feed Trip Cam Lever (A) trips.
6.
Loosen Quill Lock (E) to allow quill to retract.
7.
Set Feed Rate Lever (K) to feed rate required for
tooling and material.
8.
Select feed direction by setting Feed Direction Knob
(C) position per Table 3:
Spindle
Direction
Direction
CW
CCW
Table 3
9.
Place Quill Feed Engagement Lever (L) in Engaged
position.
10. Turn on spindle.
11. Engage Feed Trip Cam Lever (A) by pulling away
from head assembly. Feed will begin until lever trips
out at preset depth.
manual
fine
when
not
in
manual
fine
Feed
Knob
Position
Down
In
Up
Out
Down
Out
Up
In
feed
use.
feed
Note: Due to variables in tool diameter, coatings, coolant,
and materials, no specific spindle speed or feed rate
recommendations are provided. Use general shop
manuals that have data applicable to the milling and
drilling operations being performed. Or, contact the
supplier of the tooling, coolant, and material for specific
recommendations.
IMPORTANT: The power feed can be used for drills up
to 3/8" in diameter (mild steel). Use manual feed for drills
larger than 3/8".
hold up to 200 lbs. downfeed pressure on the quill
(accommodates drills up to 3/8"). Do not attempt to
adjust clutch pressure.
8.16 Draw bar operation – changing
tooling
1.
Lock spindle using spindle brake (O, Figure 8-9).
2.
Using provided wrench on drawbar hexagonal end
(Figure 8-10), loosen draw bar two or three turns
counterclockwise.
3.
Tap the top of draw bar with a soft-faced hammer to
loosen collet from taper.
4.
Remove tool from collet.
5.
Insert new tool into collet.
15
Figure 8-9
The overload clutch is factory set to
Figure 8-10
Advertisement
Table of Contents
