Pioneer DEH-P3370XM Installation Manual

DEH-P3370XM
This product conforms to CEMA cord colors.
Printed in Japan
<CRB1735-A> UC <KYMFZ/01G00000>
Connecting the Units
Note:
• This unit is for vehicles with a 12-volt battery and • When an external power amp is being used with
negative grounding. Before installing it in a recre- this system, be sure not to connect the blue/white
ational vehicle, truck or bus, check the battery lead to the amp's power terminal. Likewise, do not
voltage. connect the blue/white lead to the power terminal
• To avoid shorts in the electrical system, be sure to of the auto-antenna. Such connection could cause
disconnect the ≠ battery cable before beginning
excessive current drain and malfunction.
installation. • To avoid short-circuiting, cover the disconnected
• Refer to the owner's manual for details on con- lead with insulating tape. Especially, insulate the
necting the power amp and other units, then make unused speaker leads without fail. There is a possi-
connections correctly. bility of short-circuiting if the leads are not insulat-
• Secure the wiring with cable clamps or adhesive ed.
tape. To protect the wiring, wrap adhesive tape • To prevent incorrect connection, the input side of
around them where they lie against metal parts. the IP-BUS connector is blue, and the output side
• Route and secure all wiring so it cannot touch any is black. Connect the connectors of the same colors
moving parts, such as the gear shift, handbrake and correctly.
seat rails. Do not route wiring in places that get • If this unit is installed in a vehicle that does not
hot, such as near the heater outlet. If the insulation have an ACC (accessory) position on the ignition
of the wiring melts or gets torn, there is a danger of switch, the red lead of the unit should be connected
the wiring short-circuiting to the vehicle body. to a terminal coupled with ignition switch ON/OFF
• Don't pass the yellow lead through a hole into the operations. If this is not done, the vehicle battery
engine compartment to connect to the battery. This may be drained when you are away from the vehi-
will damage the lead insulation and cause a very cle for several hours. (Fig. 1)
dangerous short.
• Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
• Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
• When replacing fuse, be sure to use only fuse of
the rating prescribed on this unit and the fuse hold-
ACC position
er.
• Since a unique BPTL circuit is employed, never
wire so the speaker leads are directly grounded or
the left and right ≠ speaker leads are common.
• Speakers connected to this unit must be high-
• The black lead is ground. Please ground this lead
power types with minimum rating of 50 W and
separately from the ground of high-current prod-
impedance of 4 to 8 ohms. Connecting speakers
ucts such as power amps.
with output and/or impedance values other than
If you ground the products together and the ground
those noted here may result in the speakers catch-
becomes detached, there is a risk of damage to the
ing fire, emitting smoke, or becoming damaged.
products or fire.
• When this product's source is switched ON, a con-
• Cords for this product and those for other prod-
trol signal is output through the blue/white lead.
ucts may be different colors even if they have the
Connect to an external power amp's system remote
same function. When connecting this product to
control or the car's Auto-antenna relay control ter-
minal (max. 300 mA 12 V DC). If the car features another product, refer to the supplied Installation
a glass antenna, connect to the antenna booster manuals of both products and connect cords that
have the same function.
power supply terminal.
Connecting the Tuner Unit (Fig. 2)
IP-BUS Input
(Blue)
Power Supply
This Unit
No ACC position
Fig. 1
To IP-BUS Input
(Blue)
Fuse holder
Multi-CD player
(sold separately)
IP-BUS Output
(Black)
Antenna Input
Yellow (Satellite)
Black
Green
(Terrestrial)
6 m
Antenna Unit
(AN-90XM)
IP-BUS cable
(sold separately)
To Head Unit
(Refer to Fig. 3.)
Yellow
To terminal always supplied with power
regardless of ignition switch position.
Black (ground)
To vehicle (metal) body.
Fig. 2