Display Examples - Pioneer CDX-FM1277 Service Manual

Status No. Contents
26 Focus search preprocessing is in
progress while focus recovery is turned on.
27 Wait time after focus close is set up.
28 Standing by after focus close is over.
29 Setup (1/2) before T balance adjustment is started.
30 Setup (2/2) before T balance adjustment is started.
31 T balance adjustment started.
32 T balance adjustment (1/2).
33 T balance adjustment (2/2).
34 Waiting for spindle rotation to end.
Spindle rough servo.
35 Standing by after spindle rough servo is over.
36 RF AGC started.
37 RF AGC started.
38 RF AGC ending process in progress.
39 Tracking close in progress.
40 Standing by after tracking is closed.
Carriage closing in progress.
41 Focus/tracking AGC started.
42 Focus AGC started.
43 Focus AGC in progress.
44 Tracking AGC in progress.
45 Standing by after focus/tracking AGC are over.
46 Spindle processes applicable servo.
47 Check for servo close is started.
48 Check of LOCK pin started.
49 RF AGC started.
50 RF AGC in progress.
51 Standing by after RF AGC is over.

(5) Display Examples

1) During Setup (When status no. = 11)
TRK No.
11
2) During Operation (TOC read, TRK search, Play, FF and REV)
The same as in the normal mode.
3) When a Protection Error Occurred
Switch to the following displays (A) and (B) using the [BAND] switch:
(A) Error occurrence timing display in absolute time.
An example: Error occurred in 12th tune at 34'56" in absolute time.
TRK No.
12
(B) Error No. display
An example: Error #40 (Off focus is detected)
ERROR-40
MIN. SEC.
11' 11"
MIN. SEC.
34' 56"
CDX-FM1277,FM1279
Protective action
None
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus.
Off focus or spindle not locked.
Off focus.
Off focus.
Off focus.
51