National Instruments NI R Series Getting Started Manual page 7

Reconfigurable i/o module (ai, ao, dio) for pxi express, 6 ai, 18 ao, 48 dio, 1 ms/s aio, 512 mb dram, kintex-7 160t fpga

Hide thumbs Also See for NI R Series:

Table of Contents

Verifying Hardware Installation for Remote

Targets

You can verify that the system recognizes the NI PXIe-7867R by using Measurement &

Automation Explorer (MAX).

Launch MAX on the host computer.

Expand Remote Targets in the configuration tree and locate your system.

Install LabVIEW Real-Time Module 2017 and NI RIO Device Drivers July 2017 or later

on your Remote Target.

Refer to the Installing Software on the Host Computer section for information about

installing software on the host.

Refer to the PXI Express Controllers User Manual at

information on installing software on the target.

Under Remote Targets, find and expand Devices and Interfaces.

If the device does not appear, press <F5> to refresh the view in MAX. If the device does

not appear after refreshing the view, visit

Connecting the NI PXIe-7867R

NI recommends using the following cables and accessories with the NI PXIe-7867R:

6 | ni.com | NI PXIe-7867R Getting Started Guide

ni.com/manuals

ni.com/support

for troubleshooting information.

for

Table of Contents

Ni pxie-7867r