Table of Contents
Advertisement
Available languages
Available languages
Gas Connection Requirements
Liquified Petroleum Gas Fuel Tank
Only use cylinders with a minimum
capacity of 5 kg and a maximum
capacity of 15 kg. A tank of
approximately 318 mm (12.5 in) in
diameter by 580 mm (22.8 in) in
height shall be the maximum size
LPG cylinder which can be used. A
gas pressure regulator/hose assembly
is supplied.
A.
Gas pressure regulator/hose assembly
Make Gas Connection
LPG Gas Fuel Tank
IMPORTANT: An LPG gas fuel tank must be purchased
separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the grill must be used. Replacement gas pressure
regulator/hose assembly specific to your model is available
from your outdoor grill dealer.
IMPORTANT: It is forbidden to place gas cylinder on the
bottom panel of the appliance.
To Connect the LPG Gas Fuel Tank:
1.
Check LPG gas fuel tank is in the "OFF" position. If not,
turn the valve clockwise until it stops.
2.
Check that the burner control knobs are in the "OFF"
position.
3.
Remove any debris and inspect the valve connections,
port, and gas pressure regulator/hose assembly for
damage.
NOTE: Always keep the LPG cylinder at 90
orientation to provide vapor withdrawal.
A
B
318 mm
/ 12.5 in.
A
º
(upright)
A.
Gas pressure
regulator/hose
assembly
B.
LPG gas fuel tank
5.
Using your hand, turn the gas pressure regulator/hose
assembly clockwise to connect to the LPG gas fuel tank as
shown.
Hand tighten only. Use of a wrench could damage the
quick coupling nut.
A.
Gas pressure regulator/hose assembly
B.
LPG gas fuel tank
Make sure that the cylinder valve connection device
properly mates with the connection device attached to the
inlet of the pressure regulator.
6.
Open the tank valve fully by turning the valve
counterclockwise. Wait a few minutes for gas to move
through the gas line.
7.
Before lighting the grill, test all connections by brushing on
an approved noncorrosive leak-detection solution. Bubbles
will show a leak.
8.
If a leak is found, turn the tank valve off and do not use the
grill. Contact a qualified gas technician to make repairs.
9.
Go to "Check and Adjust the Burners" section.
To Disconnect the LPG Gas Fuel Tank:
1.
Check that the burner control knobs are in the "OFF"
position and the grill is cool.
2.
Check that the LPG gas fuel tank is in the "OFF" position.
If not, turn the valve clockwise until it stops.
3.
Using your hand, turn the gas pressure regulator/hose
assembly counterclockwise to disconnect to the LPG gas
fuel tank as shown.
Hand loosen only. Use of a wrench could damage the
quick coupling nut.
4.
Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the valve outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in leakage of
liquified petroleum gas.
A.
Gas pressure regulator/hose assembly
B.
LPG gas fuel tank
29
Advertisement
Table of Contents
