Maintenance; Ordering Replacement Parts - EINHELL TKS 15/250-1 UV Operating Instructions Manual

Anl.TKS 15-250-1 SPK1 V5
GB
9.1.5. Making cross cuts (Fig. 25)
Slide the cross stop (14) into one of the grooves
(49) in the table and adjust to the required angle.
(See 8.4.) If you also want to tilt the blade (4),
use the groove (49) which prevents your hand
and the cross stop from making contact with the
blade guard.
If necessary, use the stop rail (25).
Press the workpiece firmly against the cross stop
(14).
Switch on the saw.
Push the cross stop (14) and the workpiece
toward the blade in order to make the cut.
Important:
Always hold the guided part of the
workpiece. Never hold the part which is to be
cut off.
Push the cross stop (14) forward until the
workpiece is cut all the way through.
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.

10.0. Maintenance

Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.

11.0. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Model/type of device
Article number of the device
ID number of device
Number of the required replacement part
For our latest prices and information please go to
www.isc-gmbh.info
22
16.06.2005 8:16 Uhr Seite 22