Table of Contents
Advertisement
EG50 & EP50
9.2 Mounting procedure
The enclosure mounts against a flat surface using 4 fixing points. See
illustration for mounting dimensions, or use the backplate of the
enclosure as a marking guide. To do this, pull out the R-shaped clip and
remove the enclosure lid. Note how the EPIRB fits then remove it to
somewhere dry (its sea switch is now armed).
Offer the back plate into the chosen position and mark through the
mounting holes. The enclosure is supplied with a set of 25 mm (1'')
stainless steel fixings. If you are using the nuts and bolts, drill 6 mm
(1/4'') holes where you have marked. You will need a 4 mm Allen key
to tighten the bolts. If the rear of the mounting surface is inaccessible,
use the self-tapping screws supplied. Always fit washers under heads of
the screws to avoid damaging the plastic.
40
Fig. 9.2 – Enclosure Dimensions
Advertisement
Table of Contents
