Table of Contents
Advertisement
5.9.2 Re-fitting into enclosure
•
Referring to the illustration, place the EPIRB
on its side in the enclosure. As illustrated, the
TEST button is furthest from the back of the
enclosure.
•
Engage base of EPIRB into the recess in the
lever arm.
•
Push the EPIRB into the enclosure to engage
the retaining clip.
•
Bend the antenna as shown and retain it in the
recess.
•
Refit cover squarely, engaging the guides at
the top end and the rod through hole in cover.
•
Locate cover onto backplate, then snap down
over locating lug. Check that the cover is
correctly located (see following page).
•
Refit R-clip through hole in end of release rod.
Caution
Failure to fit EPIRB correctly may impair its ability to
float free in an emergency
Fig. 5.11 – EPIRB fitted in Enclosure
Fig. 5.12 – Refitting EPIRB into Enclosure
Operating Procedure
31
Advertisement
Table of Contents
