Table of Contents
Advertisement
6.
Press button
: a message appears on the display confirming your selection.
N.B.: When the oven is switched off, if the ECOMODE (Energy saving) function is selected (ON), the display
switches off after a few seconds, showing the clock. To view information on the display and switch the light
on again, just press any of the buttons or turn one of the knobs. During a cooking function if the ECOMODE
is activated the cavity lamp will be switched off after 1 minute of cooking and reactivated for each user
interaction. If, on the other hand, the function is not selected (OFF), after a few minutes the display is merely
dimmed.
STARCLEAN™ CLEANING CYCLE
To keep the oven in best condition, carry out the STARCLEAN™ cleaning cycle after each use. The cycle
takes 35 minutes, including a cooling stage, and must be carried out as follows:
For the description of this function, see the section CLEANING and the functions table on page 14.
1.
Proceed with oven cold.
2.
Wet the cellulose cloth provided under running water and wring it out so that it does not drip.
3.
Open the oven door and remove the enamelled accessories.
4.
Cover the bottom of the oven completely with the cellulose cloth.
5.
Distribute 350 ml of water evenly on the cellulose cloth. A smaller or greater amount of water could
compromise proper functioning of the cycle.
6.
Close the oven door.
IMPORTANT: To prevent steam coming out, do not open the door during the cycle.
Starclean
35 minutes water cleaning
7.
Select the symbol
8.
Press button
to confirm the choice and start the cleaning cycle. To prevent steam coming out, do
not open the door during the cycle.
9.
At the end of the cycle, remove the cellulose cloth and eliminate any residual water in the oven.
10. Then start cleaning using a sponge moistened with hot water (cleaning could be compromised if
delayed by more than 15 minutes).
Particularly stubborn grime
To eliminate particularly stubborn grime, repeat the STARCLEAN™ cycle and add a few drops of neutral
detergent while removing the grime.
KEY-LOCK
This function can be used to lock the buttons and knobs on the control panel.
To activate it, press
buttons are locked and the display shows a message and the symbol
during cooking. To deactivate it, repeat the above procedure. When the key-lock function is activated, the
oven can be switched off by turning the knob to 0 (zero). In this case, however, the previously selected
function will have to be set again.
1/1
Insert the cloth
✓
& press
with the functions knob: the word STARCLEAN™ appears on the display.
and
at the same time for at least 3 seconds. If activated, the functions of the
02:59
TIME
Cleaning
15:00
END TIME
. This function can also be activated
EN13
00:00
TIME
Cleaning
15:00
END TIME
Advertisement
Table of Contents
