Settings - Dimplex FD 9405 / L20 Operating Instructions Manual

L20

8.2 Settings

All settings which can be changed by the user are made in the
"Settings" menu item.
The following table shows the structure of the "Settings" menu.
The values shown in bold in the setting range represent the
factory default.
The settings menu can be accessed by:
 pressing the (MENU) button for approximately 5 seconds
 select the menu item "settings" with the arrow buttons and
confirm with the ENTER button (


























).

System-specific parameters
Sets the year, day, month, week day and time.
The time can be switched to daylight saving time with the clock
change option.
Operating mode settings
Selects the operating mode. Changes can be made directly using
the MODE button.
Duration of party mode in hours. After the set period has elapsed,
the system returns automatically to automatic operation. The value
for the raise is set in the menu "Heating circuit 1 – Raise".
Duration of vacation mode in days.
After the set period has elapsed, the system returns automatically
to automatic operation. The value for lowering is set in the menu
"Heating circuit 1 – Lower".
Sets the desired room set temperature and I ratio when room
temperature regulation is selected.
Settings to lower the heating characteristic curve of heating circuit
1
Sets the times during which the temperature in heating circuit 1 is
to be lowered.
Sets the temperature value by which the heating characteristic
curve of heating circuit 1 is to be lowered when the temperature is
lowered.
For each week day, it is possible to select whether Time1, Time2,
no time or both times are active when the temperature is lowered.
Operations to lower the temperature that exceed a week day are
activated or deactivated at the end of each day accordingly.
Settings to raise the heating characteristic curve of heating circuit
1
Sets the time during which the temperature in heating circuit 1 is to
be raised.
Sets the temperature value by which the heating characteristic
curve of heating circuit 1 is to be raised.
For each week day, it is possible to select whether Time1, Time2,
no time or both times are active when the temperature is raised.
Operations to raise the temperature that exceed a week day are
activated or deactivated at the end of each day accordingly.
452114.66.71 FD 9405
NOTE
Dynamic menus
The following describes the complete menu structure. During
commissioning, the control functions and menu structure are adjusted to
the specific system. Non-relevant menu items are then hidden according
to these settings.
Example: Settings for domestic hot water preparation can only be made if
the "Domestic hot water preparation" menu item is configured with "Yes"
in the preconfiguration.
Abbreviations:
HG2 = 2nd heat generator (e.g. boiler)
Wärmepumpenmanager
Setting range
13.05.13
MO ... SU
00:00 ... 23:59
Yes / No
Summer
Auto
Vacation
Party
HG2
Cooling
0 ...4 hours... 72
0 ...15 days... 150
15.0 ...20.0 °C... 30.0
001 ...060... 999
00:00 ... 23:59
00:00 ... 23:59
0K ... 19
N / T1 / T2 / Y
00:00 ... 23:59
00:00 ... 23:59
0K ... 19
N / T1 / T2 / Y
EN-9