Power - JVC GZ-MG50E Instructions Manual

14
GETTING STARTED
EN

Power

This camera's 2-way power supply system lets
you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging the Battery Pack
Power/Charge Lamp
To AC outlet
Arrow
Battery Pack Mount
Power Switch
Lock Button
To DC connector
Open the cover.
AC Adapter
(ex. AP-V17E)
BATT.
Battery Pack
1
Set the power switch to OFF.
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount.
● If the battery mount cover is attached, remove it
by sliding BATT.
3
Slide down the battery pack until it locks in
place.
4
Connect the AC adapter to the camera.
5
Connect the power cord to the AC adapter.
(AP-V14E only)
6
Plug the power cord into an AC outlet. The
power/charge lamp on the camera blinks to
indicate charging has started.
7
When the power/charge lamp goes out,
charging is finished. Unplug the power cord from
the AC outlet. Disconnect the AC adapter from
the camera.
To detach the battery pack
While sliding BATT., remove the battery pack.
Required charging time
Battery pack
BN-VF707U*
BN-VF714U
BN-VF733U
* Provided
Charging time
Approx. 1 hr. 30 min.
Approx. 2 hr. 40 min.
Approx. 5 hr. 40 min.