3
Installing the O-ring and the
Grease Fitting
Parts needed for this procedure:
1
O-ring
1
Grease fitting
Procedure
The grease fitting must be installed on the reel motor side of
the verticutter. Use the following diagram to determine the
position of each reel motor
1. Verticutter 1
2. Verticutter 2
3. Verticutter 3
4. Verticutter 4
1. Remove and discard the setscrew on the reel-motor
side plate
(Figure
6).
(Figure
5).
Figure 5
5. Verticutter 5
6. Reel motor
7. Weight
G028407
3
1. Bolts
2. Straight grease fitting
(install)
2. Install the straight grease fitting
3. For verticutter 2 and verticutter 4 locations
5), move the end weight to the opposite side of the
cutting unit.
g031275
4. If there are no bolts on the reel-motor side plate, install
them
(Figure
5. Install the O-ring on the reel motor
1. O-ring
6
1
Figure 6
3. Setscrew (remove and
discard)
(Figure
6).
(Figure
Figure 7
2
g028407
6).
(Figure
7).
g191072