Related Manuals for Kwunphi Kwun
Summary of Contents for Kwunphi Kwun
- Page 1 Kwunphi PV panels cleaning robot Kwun Maintenance Manual Read this manual carefully before using this product and store it properly for future reference.
- Page 2 Directory 1. Kwun Body...................................... 1 2. Roller brush ....................................7 3. Water Cube......................................8 4. Pressure Washer................................... 9...
-
Page 3: Kwun Body
2. After each completion of work, put the dust cover in the brush socket, on the front left and back right of the Kwun body, to prevent dust and water from entering the socket. Push the dust cover in 3. - Page 4 1. Kwun Body 1.2 Exposure Box 1. Before and after operation, make sure there are no stains or water on the inside of the exposure box and the camera lens. Clean them with clean and soft towel. 2. When using, pay attention to avoid hard objects damaging the exposure box.
- Page 5 1. Kwun Body 1.3 Shading Brush 1. When the shading brush is deformed because of incorrectly placing or operating the robot, comb the bristles out in time. 2. If the shading brush is seriously deformed and cannot be reset, replace new shading brush in time.
- Page 6 2. When working on components with 10-15° tilt angle, if the word "kwunphi" on the track is seriously worn, it indicates that the surface becomes smooth and the friction is lost. Before working, use a 1000-grit sandpaper or file to sand the track surface along the 45°...
- Page 7 1. Kwun Body 1.5 Anti-Fall Sensor 1. Before operation, make sure there are no stains or water on the anti-fall sensors. Clean them with clean and soft towel. 2. place the equipment flat when storing, the position should be free of foreign objects, and pay attention to the anti-fall sensor is not scratched by sharp objects, so as not to affect the normal use of the edge anti-fall function.
- Page 8 1. Kwun Body 1.6 Desiccant 1. The desiccant of E33H、E32H/L and E22H/L series models is stored in the side of the battery position in the body of the equipment (open the battery cover on the host to see the indicator label), do not discard for daily use.
-
Page 9: Roller Brush
2. Roller brush 2.1 Roller brush 1.If there are foreign objects such as rope and plastic bag on the component, during cleaning operation, the rotation of the brush may wrap it on the brush, resulting in deformation of the brush. During daily cleaning operation, we should observe whether the brush is wrapped by foreign objects such as rope, and if so, it needs to be cleaned in time. -
Page 10: Water Cube
3. Water Cube 3.1 Sprinkler head of water distributor 1. After a certain period of use, the water cube sprinkler on the rolling brush is easy to block the spray nozzle due to water quality or stain pollution. After plugging, the spray nozzle should be cleaned and dredged in time to prevent the blockage of the spray nozzle from affecting the cleaning effect. -
Page 11: Pressure Washer
4. Pressure Washer 4.1 Pressure Washer T1 1. When the oil level is lower than the red mark, the oil should be filled or replaced in time. The oil amount is just in the red mark of the oil mirror. The new SAE 15W-40 or equivalent 4-stroke motorcycle oil can be used. 2. - Page 12 If you have any doubts or questions about this product, please contact our customer service hotline Tel: 400-878-6861 Email address: service@kwunphi.com www.kwunphi.com...
Need help?
Do you have a question about the Kwun and is the answer not in the manual?
Questions and answers