Engaging The Deck Drive (Cutter Blades) - Scag Power Equipment SVRII-36A-23BV Operator's Manual

Section 4
To steer the mower to the right while traveling forward,
allow the right steering control lever to move back
toward the neutral position. The further the steering
control is allowed to move back, the quicker the mower
will turn right.
To stop the forward travel completely, allow the steering
control levers to return to the neutral position. If the
mower is to be parked, engage the parking brake.
- NOTE -
Smooth operation of the steering control levers will
produce smooth mower operation. While learning
the operation of the steering controls, keep the
travel speed low.
- IMPORTANT -
Do not travel forward over a curb. The mower will
hang up on the curb. Raise the deck and travel
backwards over the curb at a 45 degree angle.
REVERSE TRAVEL
CAUTION
Disengage power to the mower before backing
up. Do not mow in reverse unless absolutely
necessary and then only after observation of the
entire area behind the mower.
CAUTION
Before backing up, observe the rear for persons
and obstructions. Clear the area before backing
up. Possible injury or property damage could
occur.
To travel in reverse, use the rear reference bar as an
anchor for your hands, and slowly pull both steering
control handles back. Keep the travel speed low while
traveling in reverse. See Figure 4-4
The mower may not travel straight in reverse.
Slight adjustments may need to be made using
the steering controls.
To steer left while traveling in reverse, allow the left
steering control lever to move forward. The further
the control is allowed to move forward, the quicker the
mower will turn left.
To steer right while traveling in reverse, allow the right
steering control lever to move forward. The further
the control is allowed to move forward, the quicker the
mower will turn right.
To stop the reverse travel, allow the steering control levers
to return to the neutral position. If the mower is to be parked,
engage the parking brake.
4.8 ENGAGING THE DECK DRIVE
(CUTTER BLADES)
1. Set the throttle at about 3/4 speed. Do not attempt to
engage the deck drive at high speed as this shortens
the electric clutch life — use only moderate engine
speed when engaging the deck drive.
2. Engage the deck drive by pulling out on the yellow switch,
located on the instrument panel, to the engage position. See
Figure 4-5.
Figure 4-5. Cutter Engage Switch
19
- NOTE -
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
390S0138
R