Using The Smart Speed Tm Control System - Toro TimeCutter 75748 Operator's Manual

Using the Smart Speed
Control System
The Smart Speed TM Control-System lever, located
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
Figure 22
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
ARK
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Trimming X
grass
Bagging
Mulching
Towing
attachments
Normal
mowing
Moving the
machine
TM
(Figure 22), gives the
position.
Tow Mow
X
X
X
X
X
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
•
Trimming grass
Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
•
Towing attachments
Mow
This is the fastest speed. The suggested uses for this
g293338
speed are as follows:
•
Normal mowing
•
Moving the machine
20