UFESA CAPRI Instruction Manual page 24

Select the one cup or two cup mesh and place it (without adding coffee) into the metal funnel (13).
Pull the press bar backward and make sure that the funnel aligns with the groove in the water outlet.
Then insert the funnel into the water outlet from the "lnsert" position and fix it firmly by turning it
counterclockwise until it is at the "lock" position (Fig.1).
Place a cup on the removable shelf.
Make sure that the control knob (5) is at the "OFF" position.
Connect the appliance to the power supply.
Press the on/off button (2), the machine beeps, the "one cup" and "two cups" button lights flash and the
machine starts to warm up.
After finish preheating, the coffee indicators light solidly.
Press the "1 cup", hot water will flow out through the funnel to the cup.
After a time, when you consider that the parts are already pre−heated, press again the coffee button to
stop the water flow.
Make Espresso Coffee
Add ground coffee to the steel mesh with the measuring spoon. Then press the grounded coffee tightly
with the tamper. A spoon of grounded coffee can make about a cup of top−grade coffee.
Pull the press bar backwards and place the corresponding steel mesh for one or two cups into the metal
funnel.
Make sure that the funnel aligns with the groove in the water outlet. lnsert the funnel into the water outlet
from the "lnsert" position and fix it firmly by turning it counterclockwise until it is at the "lock" position
(Fig.1).
Place a cup on the removable shelf.
Press the coffee button to prepare coffee as needed.
The working time for brewing single−cup of coffee is 60 seconds at most, and the water pump will stop
working if the working time exceeds 60 seconds.
Additional functions-memory coffee function
After the machine has finished preheating (when "1 cup" and "2 cups" indicator lights become constant
on), press and hold the "1 cup" button, and the funnel will start to your out coffee.
When the desired amount is reached, release the "1 cup" button to stop, and you will hear a beep. The
coffee length has been memorized.
After that time, press the 1 cup coffee button again to make coffee (maximum 60 seconds, the setting is
not available if more than 60 seconds)
Note: When the time is too short, the memory will not be stored.
For the " 2 cup" memory function setting is the same as above.
To restore pre−installed setting: Press and hold "1 cup" and steam button for 3 seconds at the same time.
Both indicators will light on at the same time and beep once which will indicate that the pre-setting has
been restored
Warning: Do not leave the coffee maker unattended during making coffee while operating.
After finishing making the coffee, take the metal funnel out by turning it clockwise, and then pour the
coffee residue out with the steel mesh pressed by the press bar. Let them cool down completely, then
rinse under running water.
18