Table of Contents
Advertisement
the magnetic north as the north refer-
ence.
Position Format: Sets the position format in
which a given location reading appears.
Do not change this setting unless you
are using a map or chart that specifies a
different position format.
Map Datum: Sets the coordinate system
on which the map is structured. Do not
change this setting unless you are using
a map or chart that specifies a different
map datum.
Pressure Ref. Time: Sets the reference time
used to calculate the barometer trend.
The trend is indicated in the barometer
field.
Time Format: Sets a 12-hour, 24-hour, or
UTC time format.
Time Zone: Sets the time zone, or allows au-
tomatic selection based on GPS location.
Navigation Settings
NOTE: Some settings and options require
additional charts or hardware.
Select Settings > Navigation.
Route Labels: Sets the type of labels shown
with route turns on the map.
Auto Guidance: Sets the measurements for
the Safe Depth, Safe Height, and Shore-
line Distance, when you are using some
premium maps.
Turn Transition Activ.: Sets the turn tran-
sition to be calculated based on time or
distance.
Turn Transition Time: Sets how many
minutes before the turn that you transi-
tion to it as the next leg, when Time is
selected for the Turn Transition Activ.. You
can raise this value to help improve the
accuracy of the autopilot when navigat-
ing a route or an Auto Guidance line with
many frequent turns or at higher speeds.
For straighter routes or slower speeds,
lowering this value can improve autopilot
accuracy.
Turn Transition Dist.: Sets how far before
the turn that you transition to it as the
next leg, when Distance is selected for
the Turn Transition Activ.. You can raise
this value to help improve the accuracy of
the autopilot when navigating a route or
an Auto Guidance line with many frequent
42
turns or at higher speeds. For straighter
routes or slower speeds, lowering this
value can improve autopilot accuracy.
Route Start: Selects a starting point for route
navigation.
Other Vessel Settings
When your compatible chartplotter is con-
nected to an AIS device or VHF radio, you
can set up how other vessels are displayed
on the chartplotter.
Select Settings > Other Vessels.
AIS: Enables and disables AIS signal recep-
tion.
DSC: Enables and disables digital selective
calling (DSC).
AIS Alarm: Sets the collision alarm
ting the Safe-Zone Collision Alarm, page
12) (Enabling AIS Transmission Test
Alerts, page
13).
Restoring the Original Chartplotter
Factory Settings
NOTE: This procedure deletes all settings
information you have entered.
Select Settings > System > System Infor-
mation > Factory Settings.
Appendix
Registering Your Device
Help us better support you by completing our
on line registration today.
• Go to Garmin.com/express.
• Keep the original sales receipt, or a photo-
copy, in a safe place.
Cleaning the Screen
Cleaners containing ammonia will harm the
anti-reflective coating.
The device is coated with a special anti-re-
flective coating which is very sensitive to skin
oils, waxes, and abrasive cleaners.
1 Apply an eyeglass lens cleaner specified
as safe for anti- reflective coatings to the
cloth.
2 Gently wipe the screen with a soft, clean,
lint-free cloth.
((Set-
NOTICE
Introduction
Advertisement
Table of Contents
