Table of Contents
Advertisement
1...4
Using additional functions
The following additional functions are not required for normal use
of the wireless headphone system. You can, however, extend the
potential use of the system and adjust some of the functions to
your individual needs.
Pairing one or several stethoset receivers with the
transmitter
The stethoset receiver and the transmitter of your wireless head-
phone system are factory pre-paired. The following steps are only
necessary if you want to pair additional stethoset receivers with the
transmitter.
You can simultaneously use up to 4 paired stethoset receivers with
your transmitter. All other paired and switched-on receivers cannot
connect to the transmitter.
If more than one stethoset receiver is connected to the trans-
mitter, the remaining operating time/charge status and the
hearing profile cannot be displayed. In addition, the balance
and a hearing profile cannot be adjusted. These functions can
only be used/adjusted when only one stethoset receiver is
connected to the transmitter.
Option A (contact pairing)
Place the stethoset receiver into the charging compartment.
The stethoset receiver is paired with the transmitter.
Option B (proximity pairing)
1
Place the stethoset receiver as close as possible to the transmitter.
2
Switch the stethoset receiver on by pulling the ear bows apart.
3
Simultaneously press and hold the volume buttons
Receiver status
LED flashes red. Once paring is completed, the
Receiver status
LED flashes green and the
flashes white.
Release the buttons.
1
2
Using additional functions
Transmitter status
3
ON
+/–
until the
LED
RS 5000
| 29
Advertisement
Table of Contents
