Table of Contents
Advertisement
5. To change the default length of the
procedure (P1 or P2), press
, and then press
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
display shows the symbol
bars of the heat indicator until the
door unlocks.
7. When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
11.4 Cleaning reminder
To remind you that the Pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the appliance.
The cleaning reminder
goes out:
• after the end of the
Pyrolysis function.
• if you press
the same time while PYR
flashes in the display.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
to set
or
to set
and the
3. Close the oven door to the first
4. Hold the door with one hand on each
5. Put the door with the outer side
6. Hold the door trim (B) on the top
and
at
7. Pull the door trim to the front to
8. Hold the door glass panels on their
9. Clean the glass panel with water and
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
A
opening position (approximately 70°
angle).
side and pull it away from the
appliance at an upwards angle.
down on a soft cloth on a stable
surface. This is to prevent scratches.
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
remove it.
top edge one by one and pull them
up out of the guide.
soap. Dry the glass panel carefully.
ENGLISH
27
A
1
Advertisement
Table of Contents
