Environmental Information; Maintenance; Disc Handling; Setup - Philips MCW770 User Manual

MC W770/22.1 eng 7/23/04

Environmental information

All redundant packing material has been
omitted.We have done our utmost to
make the packaging easily separable into
three mono materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet).
Your set consists of materials which can be
recycled if disassembled by a specialised
company. Please observe the local
regulations regarding the disposal of packing
materials, exhausted batteries and old
equipment.

Maintenance

Clean the set with a
soft, slightly dampened,
lint-free cloth. Do not
use any cleaning agents
as they may have a
corrosive effect.
Do not expose the set,
batteries or discs to
humidity, rain, sand or
excessive heat (caused by
heating equipment or
direct sunlight).
Always keep the trays of
your set closed to protect the lens from
dust. If the set fails to read discs correctly
use a commonly available cleaning-CD to
clean the lens before submitting the set to
repair. Other cleaning methods may destroy
the lens.
The lens may cloud over when the set is
moved from cold to warm surroundings.
Playing a disc is not possible then. Leave the
set in a warm environment until the
moisture evaporates.
16:07 Page 9
General information

Disc handling

To take a disc out of
its box easily, press the
centre spindle while lifting
it. After use, always take
the disc out of the set
and store it in the disc case.
Never attach a sticker to a disc. If you want
to provide a disc with an inscription use a
soft felt-tipped pen and write only on the
printed side.
To clean a disc, wipe it
in a straight line from the
centre towards the edge
using a soft, lint-free cloth.
Any cleaning agents may
damage the disc!

Setup

Place the set on a flat, hard and stable
surface.
Do not position the set on top of other
equipment that might heat it up (e.g.
receiver or amplifier).
Place the apparatus in a
location with adequate
ventilation to prevent
internal heat build up.
Allow at least 10 cm
(4 inches) clearance
from the rear and the
top of the unit and 5 cm (2 inches)
from each side.
The apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
apparatus (e.g. liquid filled objects, lighted
candles).
Do not block any ventilation openings.
10 cm
4 inches
5 cm
5 cm
2 inc hes
2 inc hes
9