Network Utilities; Check Connection; Change Of Usb Port Using The Mc W770 - Philips MCW770 User Manual

MC W770/22.1 eng 7/23/04

Network utilities

Check connection

Perform a quick check of your wireless PC link connection.

Change of USB port using the MC W770

The installation of the MC W770 is optimised for the USB port used during installation.
Therefore the supplied wireless USB adapter should be connected only to this specific USB
port.
Changing the USB port can have the following disadvantages (Windows XP, 2000 and newer):
– Connecting MC W770 to your PC can require up to 2 minutes
– In some cases a new installation of wireless USB adapter driver can be necessary
If you nevertheless want to change the USB port (e.g. because you are using a USB hub),
proceed as described below.
1
Connect the wireless USB adapter to the new USB port.
Windows will recognise it and will load the appropriate drivers.Windows may display a
warning that the driver is not approved by Microsoft (message differs with Windows
version). Ignore the message and continue with the installation.
If the correct driver is not found, cancel and use Installation of the wireless USB adapter
0 0
in Custom installation first.
2
Enter Network
Utilities, select Install
different USB port
and click on Start.
The configuration on
PC side is checked
and, depending on
the PC configuration,
the following window
will appear:
Click on Next to
continue.
16:07 Page 33
Wireless PC link
33