Table of Contents

Advertisement

Available languages

Available languages

Quick Links

IMPORTANT INSTRUCTIONS -
ESDQ24 Series
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN
THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
When using electrical appliances, basic precautions should always
be followed to reduce the risk of fire, electric shock and injury to
WARNING:
ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE
FOLLOWING:
a)
Use this unit only in the manner intended by the manufacturer.If you have questions,
contact the manufacturer.
b)
Before servicing or cleaning the unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
WARNING:
ELECTRIC SHOCK AND INJURY TO PERSON, OBSERVE THE
FOLLOWING:
a)
Installation work and electrical wiring must be done by qualified person(s) in accordance
with all applicable codes and standards, including fire-related construction.
b)
Sufficient air is needed for proper combustion and exhausting of gases through the
flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating
equipment manufacturer's guideline and safety standards such as those published by
the National Fire Protection Association (NFPA) and the American Society for Heating,
Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local code authorities.
c)
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
CAUTION:
USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
CAUTION:
PROPERLY EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT
VENT EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO ATTICS, CRAWL
SPACES, OR GARAGES.
d)
Ducted fans must always be vented to the outdoors.
e)
This unit must be grounded.
f)
To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall
spray, construction dust, etc. off power unit.
g)
Read all instructions before installing or using range hood.
WARNING:
SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED
CONTROL DEVICE.
5084459 Rev. K 12-18
OPERATING MANUAL
AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
person, including the following:
TO REDUCE THE RISK OF FIRE,
TO REDUCE THE RISK OF FIRE,
FOR GENERAL VENTILATING USE ONLY. DO NOT
TO REDUCE THE RISK OF FIRE AND TO
TO REDUCE THE RISK OF FIRE, ELECTRIC
SAVE THESE INSTRUCTIONS
a)
Never leave surface units unattended at high settings. Boil overs cause smoking
and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
b)
Always turn hood ON when cooking at high heat or when flambéing food (ie. Crepes
Suzette, Cherries Jubilee, Peppercorn Beef Flambé).
c)
Clean ventilating fans frequently. Grease should not be allowed to accumulate on
fan filter.
d)
Use proper pan size. Always use cookware appropriate for the size of the surface
element.
a)
SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off
burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT.
b)
NEVER PICK UP A FLAMING PAN - You may be burned.
c)
DO NOT USE WATER, including wet dishcloths or towels -
a violent steam explosion will result.
d)
Use an extinguisher ONLY if:
I.
You know you have a Class ABC extinguisher, and you already know how to
operate it.
II.
The fire is small and contained in the area where it started.
III.
The fire department is being called.
IV.
You can fight the fire with your back to an exit.
WARNING:
THE BUILDING HAS A STRONG EFFECT ON THE AIR FLOW, NOISE AND ENERGY
USE OF THE FAN. USE THE SHORTEST, STRAIGHTEST DUCT ROUTING POSSIBLE FOR
BEST PERFORMANCE, AND AVOID INSTALLING THE FAN WITH SMALLER DUCTS THAN
RECOMMENDED. INSULATION AROUND THE DUCTS CAN REDUCE ENERGY LOSS AND
INHIBIT MOLD GROWTH. FANS INSTALLED WITH EXISTING DUCTS MAY NOT ACHIEVE
THEIR RATED AIRFLOW.
www.airkinglimited.com
Range Hood
WARNING:
TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE:
WARNING:
TO REDUCE THE RISK OF INJURY TO PERSONS
IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:
WARNING:
TO REDUCE THE RISK OF FIRE, USE ONLY
METAL DUCTWORK.
THE DUCTING FROM THIS FAN TO THE OUTSIDE OF
1 of 12

Advertisement

Table of Contents
loading

Summary of Contents for AirKing ESDQ24 Series

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL ESDQ24 Series Range Hood READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2: Installation Instructions

    INSTALLATION INSTRUCTIONS The thickness of the strips should be the same as the recess of the cabinet and they should be approximately 2" wide. CAUTION: Install the strips using appropriate length wood screws (not included). Make sure the MAKE SURE POWER IS SWITCHED OFF AT strips line up to the keyhole slots of the range hood.
  • Page 3 SECTION 4 Horizontal Blower Installation for Ducted Range Hoods NOTE: When reinstalling the blower, ensure 1/8" that the blower is facing the same way as how Keyhole you have chosen to duct it. With the opening of the blower facing the Studs direction you have chosen to duct the hood, place the blower mounting brackets...
  • Page 4: Maintenance

    SECTION 10 Maintenance CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT. Filters Grease Filter - Included with your range hood is an aluminum grease filter that should be washed at least once a month. The filter is dishwasher safe and should be washed in a mild soap or detergent.
  • Page 5: Troubleshooting Guide

    Troubleshooting Guide Trouble Probable Cause Suggested Remedy 1. Hood does not operate when the switch is on. A fuse may be blown or a circuit tripped. Replace fuse or reset circuit breaker. Wiring is not connected properly. Turn off power to unit. Check that all wires are connected. 2.
  • Page 6: Replacement Parts Diagram

    REPLACEMENT PARTS DIAGRAM # de pièce de Qté. Description remplacement Damper Assembly 5S1199080 Switch Plate White 5S1421003 Black 5S1421006 Motor Switch White 5S1418003 Black 5S1418006 Light Switch White 5S1418003 Black 5S1418006 Louver Plate White 5S1429003 Black 5S1429006 GU24 Lamp Holder Assembly 5S1199703 Capacitor Harness 5S1145056...
  • Page 7: Instructions Générales De Sécurité

    INSTRUCCIONES IMPORTANTES – MANUAL DE OPERACIÓN Séries ESDQ24 Hotte de cuisinière LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 8: Instructions Pour L'installation

    INSTRUCTIONS POUR L’INSTALLATION L’épaisseur des bandes doit correspondre au retrait de l'armoire et doit avoir une largeur d'environ 5 cm. MISE EN GARDE : Posez les bandes à l’aide de vis à bois (non comprises) de longueur appropriée. Assurez-vous ASSUREZ-VOUS QUE que les bandes sont alignées aux encoches en trou de serrure de la hotte.
  • Page 9 SECTION 4 Évacuation horizontale Installation du ventilateur pour hottes avec évacuation REMARQUE : lorsque vous réinstallez le ventilateur, assurez-vous de le remettre Encoche exactement à la même place. en trou de Une fois l’ouverture du ventilateur dans la serrure Goujons direction choisie, placez les supports de fixation du ventilateur (de chaque côté...
  • Page 10: Entretien

    SECTION 10 Entretien MISE EN GARDE : ASSUREZ-VOUS QUE L’ALIMENTATION ÉLECTRIQUE EST COUPÉE À PARTIR DU PANNEAU DE DISTRIBUTION AVANT DE PROCÉDER À L’ENTRETIEN DE L’APPAREIL. Filtres Filtre à graisse - De filtre à graisse en aluminium, que vous devez nettoyer au moins une fois par mois, sont inclus avec la hotte.
  • Page 11: Guide De Dépannage

    Guide de dépannage Trouble Cause possible Solution suggérée 1. La hotte ne fonctionne pas lorsque l’interrupteur 1a. Un fusible peut être grillé ou un disjoncteur peut Remplacer le fusible ou réinitialiser le disjoncteur. est à EN (ON). être déclenché. 1b. Le câblage n’est pas raccordé correctement. Couper l’alimentation de l’unité.
  • Page 12 TABLEAU DES PIÈCES DE RECHANGE # de pièce de Qté. Description remplacement Assemblement de adaptateur 5S1199080 Plaque d’interrupteur Blanc 5S1421003 Noir 5S1421006 Interrupteur du moteur Blanc 5S1418003 Noir 5S1418006 Interrupteur de lumière Blanc 5S1418003 Noir 5S1418006 Plaque de persienne Blanc 5S1429003 Noir 5S1429006...

Table of Contents