Connecting The Tms-Ma Cables - Telecor TMS-MA Installation Manual

Media source model a
Table of Contents

Advertisement

B.3 Connecting the TMS-MA Cables
Once you have mounted the TMS-MA unit into the rack, you can then connect the power, audio
cable harness, and optional (provided by customer) antenna.
The CHAP-TMS-MA audio cable harness connects the TMS-MA to the Telecor II's ATBU-2 or
Telecor XL's ATP-AX2. It has a 3-pin insulation displacement connector (IDC) at the TMS-MA
end and a 2-pin IDC at the T2/XL end.
1.
Connect the power adapter cord to the TMS-MA and plug it into the mains.
Optional: plug an FM antenna into the 75Ω antenna port and run the antenna wire along
2.
the outside of the rack.
3.
On the rear of the TMS-MA, plug the 3-pin IDC of the CHAP-TMS-MA cable harness
into the audio output port as in the above diagram.
4.
Plug the 2-pin IDC end of the CHAP-TMS-MA audio cable harness into the
input of the T2/XL's Audio Input board (ATP-AX2 on an XL System or
or
TAPE
AUX
ATBU-2 on a T2 system).
TMS-MA Telecor Media Source Model A Installation Manual
CHAP-TMS-MA Audio Cable Harness
Connections to the TMS-MA
Audio Connection to the T2/XL System
TUNER,
13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TMS-MA and is the answer not in the manual?

Table of Contents