Table of Contents
Advertisement
5. TROUBLESHOOTING
5.1 SOFT RESET
If your FREECOM 1+/2+ stops responding, reset it in one of these ways:
Turning it off and then on again (see Getting Started on page 5).
●
Using the supplied USB cable, connect your unit to the computer or wall charger for 30
●
seconds.
5.2 RESET PAIRING
The options below delete all paired units or devices.
To reset mobile device pairing:
1. While in standby mode, press
The LED flashes red and blue.
2. Press
and
for 2 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
To reset intercom pairing:
1. While in standby mode, press
The LED flashes red
2. Press
and
for 2 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
5.3 RESET TO FACTORY SETTINGS
This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your FREECOM 1+/2+ is in Standby mode (see FREECOM 1+/2+ LED Indications on page 18).
2. Simultaneously press
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
All manuals and user guides at all-guides.com
for 5 seconds.
for 5 seconds.
+
+
for 5 seconds.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FREECOM 1 + and is the answer not in the manual?
Questions and answers