Rip Settings - TP-Link TD-9970B User Manual

TD-W9970/TD-W9970B
2. Enter the following data:
Destination IP Address: The Destination IP Address is the address of the network or host

that you want to assign to a static route.
Subnet Mask: The Subnet Mask determines which portion of an IP Address is the network

portion, and which portion is the host portion.
Gateway: Here you should type the Gateway address correctly, and the option for Interface

will adopt the default Gateway address for the Static Route.
Interface: Select the Interface name in the text box, or else, the default Use Interface will be

adopted for the Static Route.
Status: Select Enabled or Disabled from the drop-down list.

3. Click Save to save your settings as shown in Figure 4-66.
To modify or delete an existing entry:
1. Find the desired entry in the table.
2. Click Edit as desired on the Edit column.
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete selected entries.

4.11.3 RIP Settings

Choose "Route Settings""RIP Settings", you can see the RIP (Routing Information Protocol)
screen which allows you to configure the RIP.

Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
300Mbps Wireless N USB VDSL/ADSL Modem Router User Guide
Figure 4-66
Figure 4-67
76