Removing The Mower Deck - Toro TimeCutter 4200 Operator's Manual

3. To lower the front of the mower, loosen the
adjustment nut.
4. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip; refer to
the Front-to-Rear Blade Slope (page
5. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to Checking the Side-to-Side Level (page
41).

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
Checking
2. Shut off the engine, remove the key, and wait
42).
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. On 1 side of the machine, remove the washer
and hairpin cotter from the deck pin
44
63).
Figure 63
3. Deck bracket
ARK
g014635
(Figure 64).