Electrolux IK2670BNR User Manual page 15

Problem
A or symbol is
shown instead of numbers
on the Temperature Dis‐
play.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastFreeze"
or "FastCool", or after
changing the temperature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Possible cause
The door is left open.
Temperature sensor
problem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastFreeze func‐
tion" or "FastCool func‐
tion" is switched on.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
ENGLISH
Solution
Close the door. Refer to
"Door open alarm"
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation".
Wait few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion" or "FastCool function".
The compressor starts after
a period of time.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
15