Table of Contents
Advertisement
22
www.aeg.com
13. TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the
hot water supply to decrease energy consumption.
14. INSTALLATION
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
Wattage (W)
bar (minimum and maximum)
kPa (minimum and maximum)
Cold water or hot water
Place settings
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Secure dishwasher with
brackets and screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
If floor is not level, adjust
levelling legs to suit
596 / 818 - 898 / 575
200 - 240
50 / 60
1550-2200
0.5 - 8
50 - 800
max 60 °C
2)
15
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
600 mm max
300 mm min
POWER OUTLET
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
Advertisement
Table of Contents
