Subscribe to Our Youtube Channel
Related Manuals for Pelonis PTH15A4BGB
Summary of Contents for Pelonis PTH15A4BGB
- Page 1 145X210mm OWNER’S MANUAL Ceramic Tower Heater MODEL:PTH15A4BGB PLEASE READ AND SAVE THESE INSTRUCTIONS...
-
Page 2: Important Instructions
IMPORTANT INSTRUCTIONS PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances,basic precautions should always be followed to reduce the risk of fire,electric shock,and injury to persons, including the following: 1. Read all instructions before using heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. - Page 3 could result in an electric shock hazard. 10. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working. 11. CAUTION: It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug.
- Page 4 PART FIGURE Display screen Control panel Front cover Grille Rear cover Base Dispaly area Oscillation Timer -, + Function ON/OFF...
- Page 5 OPERATING INSTRUCTION Check before turning on the machine 1. Check if the power wire is under good condition. 2. The product adopts 120V AC power supply, before use, please confirm if the rated current of the power socket meets the local requirements with safe grounding device, otherwise, please replace it with the qualified socket.
- Page 6 Temperature sensor short circuit, open circuit protection function No matter in what mode, the temperature sensor appears short circuit or open circuit, digital screen displays "E1" or "E2" and constantly flicker, while any key operation is invalid and the buzzer rings 10 times. Safety protection In the start state, when the room temperature TH is above 122°F, close all outputs system, The digital screen displays "FF"...
-
Page 7: Remote Control
Remote control ON/OFF key Function key “+”key “-”key Timer key Oscillation key MAIN TECHNOLOGY SPECIFICATIONS Power supply: AC 120V ~ 60Hz POWER REGULATION RANGE (W) MODEL LOW HIGH LOW OSC HIGH OSC 1500 1500 PHTPU1501 Troubleshooting If the product does not operate or does not operate properly, first check according to the following list. -
Page 8: Cleaning And Storage
CLEANING AND STORAGE It is recommended that the heater be cleaned at least one time during the operating season in order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off- season storage. - Page 9 759 Bloomfield Ave #386 West Caldwell, NJ 07006...
- Page 10 PELONIS PELONIS PELONIS PELONIS PELONIS PELONIS PELONIS...
Need help?
Do you have a question about the PTH15A4BGB and is the answer not in the manual?
Questions and answers
How can I remove the E2 message?
The "E2" message on the Pelonis PTH15A4BGB indicates a temperature sensor issue (either a short circuit or an open circuit). When this occurs, the digital screen displays "E2" and blinks constantly, while the heater does not respond to button presses and the buzzer rings 10 times. To resolve this issue, try the following steps:
1. Turn off the heater.
2. Unplug it from the power outlet.
3. Wait a few minutes for the unit to reset.
4. Plug it back in and turn it on.
If the issue persists, the temperature sensor may be faulty, and you should contact a qualified technician or the manufacturer for further assistance.
This answer is automatically generated