Table of Contents
Advertisement
Section 3 - Configuration
If you clicked on Edit or Add Rule, the following options will appear:
Name
Enter a name for the rule.
Local IP
Enter the IP address of the computer on your local network
that you want to allow the incoming service to. Alternatively,
select the device from the drop-down menu.
TCP Port
Enter the TCP ports that you want to open. You can enter a
single port or a range of ports. Separate ports with a comma
(for example: 24,1009,3000-4000).
UDP Port
Enter the UDP ports that you want to open. You can enter a
single port or a range of ports. Separate ports with a comma
(for example: 24,1009,3000-4000).
Schedule
Use the drop-down menu to select the time schedule that
the rule will be enabled for. The schedule may be set to
Always Enable, or you can create your own schedules in the
Schedules section. Refer to Time & Schedule - Schedule on
page 89 for more information.
D-Link DIR-2640 User Manual
79
Advertisement
Table of Contents
