Titan 105 Installation, Maintenance, And Parts Manual page 14

Hide thumbs Also See for 105:

With available take-up tighten belts enough to keep from slipping during operation. Ideal belt tension

is the lowest tension at which the belt will not slip under peak load conditions. The drive side of the

belt(s) should be straight across and the slack side should show a slight bow.

Do not place new belt(s) on worn sheaves.

If multiple belts are used, replace all belts with a new set or matched belts.

Do not use belt dressing on belt(s) which are slipping. Belt dressing will damage the belt and cause

early failure. Tighten belt(s) to proper tension, or if dirty, clean the belt(s) with a commercial

rubber solvent.

CHECK V-BELTS AND SHEAVES ONLY WHEN CONVEYOR IS

DANGER

STOPPED!

CHAIN & SPROCKETS

For longest chain life a constant film or oil is recommended. We recommend a good quality non-detergent petro-

leum base oil. Use the chart below

WARNING

SHUT OFF CONVEYOR BEFORE USING OIL CAN OR BRUSH TO APPLY OIL!

REMEMBER - ALL GUARDS AND BOTTOM PANS, IF PROVIDED, MUST BE

REPLACED BEFORE RUNNING CONVEYOR. TITAN INDUSTRIES IS NOT

DANGER

RESPONSIBLE FOR INjURIES CAUSED BY NOT COMPLYING WITH

SAFETY INSTRUCTIONS.

TEMPERATURE

20 degrees - 40 degrees F

40 degrees - 100 degrees F

100 degrees - 120 degrees F

120 degrees - 140 degrees F

RECOMMENDED OIL

VISCOSITY

SAE 20

SAE 30

SAE 40

SAE 50

5/12

Table of Contents